Resetting The Rtcp09 - Gorgy Timing RADIO TIMING CP09 Guia Del Usuario

If the RTCP09 does not respond to your commands, or if the screen hangs, you can reset it.
RESET (restarting)
►
Click "RESET" located at the back of the RTCP09, near the RJ-45 network connector.
All the RTCP09
be lost. A fresh synchronization will therefore be necessary for the
right time following a RESET.
► Factory reset (resetting of factory settings):
This process will reset the
will be lost (time zone, DST policy, specific settings, etc.)
NOTE
This however stores the relay output programming calendars. These cannot
be deleted by such a reset.
On the front interfaces, press the Left + Right + OK + Escape keys.
Via Web interface (see section 5.10 REBOOTING).
At the back of the RTCP09, press and hold down the FD (Factory Default)
button, and press the Reset button once, while holding down the FD button until
MDE-RTCP09-3060V2.2
settings will be stored when you do so. Only the time information will
RTCP09 to its factory settings. All the time input/out settings
the screen switches off a second time.
(Pressing Reset will lead to a 1
8. RESETTING THE
OR
OR
restart).
st
RTCP09
RTCP09 to show the
125