Operation - cecotec Cumbia POWER ESPRESSO 20 MATIC Manual De Instrucciones

ENGLISH
process is over (about 2 minutes). Once the appliance has reached its optimal temperature, the
light will stop flashing.
Press the espresso button. Hot water will come out from the machine, use the water to clean
filters or cups.

3. OPERATION

Making coffee
Place the filter in the filter holder.
While the appliance is preheating, fill the filter with coffee and use the end part of the spoon
to press it down.
Hold the portafilter, introduce the filter holder into the machine and place an empty cup on the
removable grid.
Press the espresso button in order to brew 1 single espresso.
Press the double espresso button in order to brew 1 double espresso.
Note: These 2 previous functions are customizable. If you want to change the preset amount of
drink previously saved, do the following:
Press the single or double espresso button. Once you have obtained the desired amount of
drink, press again the previous button to stop drink from being dispensed. Next time the button
is pressed, the machine will dispense the new saved amount.
Press the manual control button once in order to serve the desired amount of coffee, and press
the same button again to stop it.
Steam and froth function
Note: It is suggested to release some steam before frothing milk.
Press the steam button. The light indicator will turn red and flash. Once the preheating process
is over, the light will stop flashing.
Pour milk into a jug and fill it up to 1/3. Introduce the steam nozzle and slowly turn the steam
dial.
Recommendation: It is recommended to use cold whole milk for optimal results.
Note: The steam tube degree can be adjusted.
Warning: Clean the steam exit with a wet sponge immediately after use. Then, remove the
steam tube and clean the duct's inside part. It is also recommended to emit steam again in
order to clean possible milk remaining inside the tube.
Hot water function
Press the power button, the light indicator will turn blue indicating that the machine is
preheating. Once the light stops flashing, the machine is ready.
Turn the dial to the ON position, hot water will be dispensed. This hot water can be used for
36
01509_Cumbia Power Espresso 20 Matic _Manual_YV_02020218.indd 36 01509_Cumbia Power Espresso 20 Matic _Manual_YV_02020218.indd 36 18/2/20 17:00 18/2/20 17:00