Replacing Carbon Brushes - Makita BJS161 Manual De Instrucciones

Workpiece thickness (mm)
Less than 0.8
0.8 - 1.3
More than 1.3
006428
After adjusting the clearance, tighten the screw securely.
Storing hex wrench
010087
Store the hex wrench as shown in the figure when not in
use.
OPERATION
Lubrication
1
2
3
010084
Before operation, lubricate the contact point of the
center blade and the pin. To keep good cutting
performance, also use a cutting lubricant from time to
time during operation.
OPERATION
010098
Turn the tool on and set front ends of the side blades on
the workpiece. Now simply move the tool forward,
keeping the side blades flush with the workpiece
surface.
Marking on thickness gauge
0.5
1.0
1.5
1. Hex wrench
1
1. Oil supply
2. Center blade
3. Pin
010099
CAUTION:
When cutting a small portion of the workpiece, you
•
may have difficulty completing the end of the cut. In
that case, try to cut it again, pulling the workpiece
back slightly.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Insert the top end of slotted bit screwdriver into the notch
in the tool and remove the holder cap cover by lifting it
up.
6
1. Limit mark
1