ROBBE Red Hawk KIT Instrucciones De Montaje página 4

Fig. 5
- Connect the aileron pushrods to the servo output arms.
- Set the ailerons to centre. Screw the clevises in or out as
required, and connect them to the aileron horns.
Fig. 6
- Run the servo leads through the tunnel to the other side
of the wing.
Fig. 7
- The wing with the two aileron servos installed and con-
nected.
Fig. 8
- Draw the aileron servo leads through to the top of the
wing centre section.
Fig. 9
- Four-channel receiver: connect the aileron servo leads to
a Y-lead for connection to one receiver channel.
Fig. 10
- 5-channel or 7-channel receiver: connect the aileron ser-
vos to two additional extension leads for connection to
two separate receiver channels.
Figs. 11 and 12
- Deploy the servo leads neatly by cutting cable ducts in
the top surface of the wing, and pressing the leads into
them.
The main undercarriage
Fig. 13
- The component parts of the main undercarriage.
Fig. 14
- Undo the nuts, washers and springs.
Assembly and operating instructions
Red Hawk KIT, Red Hawk ARF
Fig. 15
- Place the main undercarriage on the mounting plate and
add the springs, washers and nuts, taking care to keep
them in the correct order.
Fig. 16
- Attach one of the prepared wheel / wheel spat assemblies
to the main undercarriage unit. Lock the nuts against
each other to hold the spats in place, but ensure that the
wheels are free to rotate.
Fig. 17
- Install the second wheel and spat.
Fig. 18
- The main undercarriage, ready to install.
Installing the receiving system in the fuselage
Fig. 19
- Remove the output arms from the rudder and elevator
servos.
- Fit the servos in the fuselage, running the leads forward
into the receiver bay.
Fig. 20
- Connect the servo output arms to the pushrods.
- Fit the output arms on the servos, and secure them with
the servo output screws.
- Secure each servo with a drop of cyano at the mounting
lugs.
Fig. 21
- Connect the servos to the receiver in the sequence stat-
ed in the RC system instructions.
- Unwind the flexible wire aerial attached to the receiver.
4
Fig. 22
- Place the receiver in the receiver bay.
- Press the receiver aerial into the cable duct in the outside
of the fuselage, and run it to the tail of the model.
Installing the power system
Figs. 23 and 24
- Read the operating instructions supplied with the various
components before completing the next stage.
- Solder the appropriate connectors to the leads attached
to the motor, speed controller and battery, and insulate
each joint with a heat-shrink sleeve.
Fig. 25
- Attach the motor to the motor bulkhead using four M3 x 8
screws and washers.
Fig. 26
- Switch the transmitter on, and set the throttle stick to idle.
- Connect the speed controller to the motor and receiver,
and connect the battery.
- Hold the motor bulkhead firmly, and slowly open the
throttle.
- The motor shaft should now rotate in the direction shown
by the arrow; if not, swap over any two of the three wires
between the motor and the speed controller.
- If necessary, mark which pairs of wire are connected
together, then disconnect the motor from the speed con-
troller.
Fig. 27
- Install the speed controller in the fuselage, running the
power wires forward and out of the fuselage nose.
No. 3241KIT
No. 3241ARF