TRAPP BIO 300 s Manual De Instrucciones página 51

www.trapp.com.br
1
Attention!
If motor is hot when changing oil, be
careful to remove oil container. Hot oil
is released with more pressure, and may
cause burns.
5. When oil has been fully drained, screw back oil
container.
6. Remove the crankcase oil inlet cover (2) and insert
20W50 oil according to the motor model.
a. 13.5 HP motor (Briggs & Stratton): 1.15 liters.
b. 15 HP motor (TRAPP / Lifan): 1.1 liters.
2
Image merely illustrative
7. Check the level of oil with indicating rod (2). For
better reading, firmly hold cover on tube before
removing the rod. Keep oil at rod "Full" level.
Note:
Frequently check level of motor oil to

prevent damage due to lack of oil.
Note:
The gasoline motors that leave the
factory equipped in the shredders have an oil
level sensor; in case the motor does not have
the minimum amount of oil it does not work.
Violating this sensor causes the loss of warranty.
Attention!
All maintenance or cleaning should be done

with the power off and the spark plug wire
disconnected.
Disposal of oil and oil containers should

follow the oil manufacturer's instructions on
disposal. Do not discharge on the floor or in
the common trashcan.
51