TRAPP BIO 300 s Manual De Instrucciones página 57

www.trapp.com.br
Counter-blade
The horizontal counter-blade should be turned when
present wearing. After using both sides, the counter-
blade must be replaced.
To remove the counter-blade proceeds as follows:
1. Remove the side entrance funnel.
2. Remove the main entrance funnel.
3. Remove the fasteners from bearing and shaft.
4. Remove the side fasteners.
5. Remove the fastening elements of the counter-
blade (5), after this procedure you can remove it
for sharpening or exchange it if it is too worn, as
shown in Figure 13.
1
Figure 13
Cutting hazard during the maintenance

of blades and counter-blade. When
doing any cleaning or maintenance,
use correct tools and protective
equipment.
Repairs or cleaning should be done

with the machine disconnected.
3
4
Attention!
2
5
Image merely illustrative
57