dirna Bergstrom bycool blue line FLAT Instrucciones De Montaje página 32

FLAT
EN
9
Position the console using original screws and
align in the most ideal position in the Bycool,
namely when the positions of the original screws
coincide, remembering that the highest lugs
must be situated in the rear section.
10
Once these operations are complete, dismount
the console, turning the nuts (A) until the
EPDM seal is compressed between 3 and 5
mm approximately; then tighten the nuts to the
base of the Bycool (B) and the upper nuts of the
support (C).
Important: In order to prevent water from dripping, ensure the seal is tight against the base of
!
the Bycool - Torque 1.3 to 1.8 Kg, as shown in this diagram.
Tighten the nuts (A) until the seal is tight between 3 and 5 mm and then tighten nuts (B) and
(C).
11 Mount the console again using the original
screws.
Only for standard cabins (L2H2)
Cover
32
®