SUOMY MX TOURER Manual De Instrucciones página 27

Then press quite hard on the two side straps (C-D) making the profile's interior attach itself to the
polystyrene. After fastening, check that the shell is snug inside the helmet (foam padding).
REMOVABLE PADS
The comfort pads are fastened to the shell by means of 5 attachment points, namely:
• two tabs located respectively at the front and back of the pad, embedded in the hooks inserted
in the polystyrene (A B)
• 3 snap-on buttons placed directly on the inner protection pad (C D E).
Removal:
To remove the comfort pads you firstly have to detach the tabs (A B) in the front and rear. of the
extracting them from the specific fastening system in the cavity between the polystyrene and the
shell.
Pull the rear tab of the pad towards the outside of the helmet until it has been completely detached.
Then detach the three snap-on buttons C-D and E.
Assembly
To reassemble the pad, first align the inner snap-on buttons (C and D) and press lightly until they
are attached. Do the same with the third button (E). Then insert the two tabs A and B in their
specific housings on the protection pad. Ensure the pad's profile is aligned with the one on the
helmet's outer shell. Ensure the pad is securely fastened to the helmet.
Before using the helmet, check that the pads and inner cap are positioned correctly and
securely fastened to the strap and the shell. Improper positioning and/or ineffective
attachment can impact the effectiveness of the retention system: if this occurs refrain from
using the helmet.
USE and MAINTENANCE
See Figure 4a/b
Eng
figure 4a
figure 4b
25