SUOMY MX TOURER Manual De Instrucciones página 29

position.
Unscrew the middle screw (D) using the special tool provided and unfasten the cover mechanism by pulling it upwards. Unhook the visor by
pressing lightly on the outside of the helmet. Repeat these steps on the opposite side.
Assembly:
To ensure the best possible functioning of the rotation system, ensure that all parts (pins and their housings on the helmet, locking
nuts and accessories, visor surfaces in contact with moving parts) are perfectly clean prior to installation of the visor.
Place the visor on the mechanism so that the rotation housing (G) is inserted into the rotation ring (H). Place the cover above the visor to align
the hole in the cover with the one on the shell (D Figure 5b).
Insert the screw B into the hole and tighten it.
Reassemble the outer belt cover, taking care to fit the upper and lower points of constraint in their housings.
Repeat these steps for the opposite side.
Once you have finished the assembly, check that the visor is firmly bound to the helmet, which rotates freely and which locks properly in the
locking positions, by repeatedly performing a few opening and closing movements.
If this does not happen and the visor's rotation mechanism does not work properly, refrain from using the helmet and contact Suomy
authorised personnel only.
Adjustment
If, after replacement or prolonged use, infiltrations occur on the visor's edges when it is in the fully closed position, it may be necessary to adjust
the mechanism which allows the visor to be moved up and down.
Raise the visor until it reaches the fully open position.
Disassemble the outer belt cover as described above.
Slightly loosen the middle screw located below the belt cover (D fig 5b).
Press firmly on the front of the visor, ensuring that it firmly adheres to the edge, and then tighten the screw while continuing to put pressure on
the visor. Carry out this procedure on both sides.
USE and MAINTENANCE
See Figure 5c
Eng
27