Installation - EdilKamin MODO 2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 44

INSTALLATION

The stove is delivered on a pallet inside a cardboard box.
First of all, remove the stove from its packaging, check
that the model is the one ordered, and make sure it has not
been damaged during transportation. Any complaints must
be made to the carrier (in writing on the accompanying
consignment note) upon receipt.
Refer to the local regulations in the country of use for assem-
by and anything else not expressly shown. In Italy, refer to
standard UNI 10683, along with any regional or local health
authority regulations.
If the stove is to be installed in a condominium, consult the
administration before installing.
In France, it is necessary to refer to Decree 2008-1231.
COMPATIBILITY WITH OTHER DEVICES
According to the regulation UNI 10683, the stove must
A
NOT be installed in the same room as extractors, type B
gas equipment or any device creating vacuum conditions.
Warning: extraction fans operating in the same room
can cause problems.
SAFETY DISTANCES
Place the stove away from fl ammable materials and objects;
leave a distance of 80 cm from furniture and at least 10 cm
Fig. 3
from the wall.
These distances are for furniture or walls which are either fi re-
proof or able to withstand being raised to an environmental
temperature of 80°C without overheating to the point of
catching fi re.
The air circulation which is created around the stove thanks
to these distances ensures effi cient ventilation and improves
thermal effi ciency.
- In the event the stove is to be installed on a fl oor made with
a fl ammable material, we recommend placing it on a steel
plate available as an optional.
EDILKAMIN declines any responsibility for installations not
complying with the laws in force and for misuse of the stove.
AIR INTAKE
The room of installation must have a suitable outside air
intake with a through surface area of at least 200 cm² (Ø
16), in order to replenish the burnt oxygen and ensure an
adequate combustion air fl ow.
Alternatively, combustion air can be taken through a pipe with
a diameter of 8 cm connected directly to the back of the stove.
To connect the pipe to the stove, remove the pre-cut plug (A -
Illustr. 3) and fasten the outside air intake pipe."
- 23
-

Publicidad

Tabla de contenido
loading

Tabla de contenido