Changing The DustBag - SOLAC AB2750 Instrucciones De Uso

Ocultar thumbs Ver también para AB2750:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
• If you wish, use the handle (21) to carry the vacuum cleaner while using it, and
to get in to difficult places.
CHANGING THE DUSTBAG, THE MOTOR
PROTECTION FILTER AND THE AIR OUTLET
FILTER
CHANGING THE DUSTBAG 3
• When the indicator (6) is completely red, a new paper bag must be installed in
the vacuum cleaner. This indicator may show red if something is stuck in the
flexible tube or in an attachment. To find out if that is the case, unplug the
vacuum cleaner, remove the flexible pipe, and turn the vacuum cleaner on again.
If the indicator does not show red, clean the flexible tube and its attachment.
• To change the paper bag, unplug the vacuum cleaner and proceed as follows:
1. Open the dust-bag container by pressing on the latch (1), and lifting the
cover (fig. 1).
2. The paper bag has a hygienic seal on its intake opening to ensure maximum
hygiene. When removing the bag, hold it tightly by the side edges and pull
the central cardboard piece upwards (fig. 4).
3. Place the new paper bag on the dust-bag carrier fitting (22). Make sure the
arrow on the bottom edge of the bag is pointing downwards, and check that
the cardboard edge of the bag is inside the guide of the dust-bag carrier
accessory (22), slide the bag until the end of the accessory guide (22) (fig. 5).
The bag must be fitted correctly: confirm this by checking the cardboard
edge on the bag. It must match the intake opening on the vacuum cleaner.
THE MOTOR PROTECTION FILTER 9
• When the motor protection filter (9) is dirty (once or twice a year, depending on
use), open the vacuum cleaner and remove the vertical filter (8) by pulling the
top upward (fig. 6). Shake the protection filter well or wash it if it is very dirty,
and leave it to dry completely. Never use the vacuum cleaner without the
motor protection filter.
CHANGING THE AIR OUTLET FILTER 7
• The air outlet filter (7) must also be changed once or twice a year. Remove the
air outlet filter cover (7) by pressing on the top of the cover-opening button (8)
until you hear a click (fig. 7) and remove the filter. Shake the protection filter
well, or wash it if very dirty, and allow it to dry completely; refit it when clean.
Never use the vacuum cleaner without the air outlet filter.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido