schulink SPC3 Manual Del Usuario página 12

THE STATUS SCREEN
Software Update Available –
A.
Indicates that a software update is
available for the charger itself (not the
App). Tapping the icon will load the new
software from the Cloud and restart the
charger. This may take several minutes.
Do not unplug the charger while the
update is in progress.
B. Charge Indicator Ring – The color
of this ring and the amount of the
circle that is filled indicates the
charge level. A completely green ring
indicates the battery is fully charged.
This corresponds to the percentage
displayed in the center.
C. Charge Time – The amount of time
needed to charge the battery when it
was first connected.
D. Charge Pause Switch – The sliding
switch starts or pauses the charging
process. The current status is shown
above the switch. You can pause the
charge while watching the voltage drop
to see if there is a power draw from the
battery. The charging process will not be
reset unless the charger is unplugged
and plugged in again. NOTE: This
charger is also a maintainer and it is not
necessary to stop the charging process;
the charger will automatically switch to
maintenance mode when the battery is
fully charged.
E. Connected to the Cloud – When
blue, this indicates the charger is
connected to the Cloud. When the
charger is not connected to the Cloud,
the icon turns gray.
F. Connected to AC – Indicates the
charger is plugged into a live 120V AC
outlet. If the charger is unplugged from
the AC, the charger will power itself off
of the battery for five minutes, sending
out a loss of power signal to the app.
When no AC power is detected, the
icon turns gray.
G. Connected to Battery – When
green, indicates that the battery is
properly connected to the charger.
When clamps are reversed or not
connected, the icon turns gray.
H. Battery Voltage – Shows battery
voltage. This voltage varies throughout
the charging cycle, but gives an
indication of the health of the battery.
If the value goes below 12.5V during
Float or Maintain modes, this could
indicate excessive draw on the
battery by the vehicle or the battery
approaching the end of its life.
I. Charge Amps – Shows the current the
charger is putting into the battery.
J. Charger Temperature – Shows the
charger's temperature status. The
charger will automatically lower
the charge current if it detects the
temperature is higher than normal.
Use the house icon
HOME screen.
NOTE: The App will time out after 15
minutes of inactivity, and you will need to
log in again to use it.
H
• 12 •
to return to the
B
C
D
I
A
E F G
J