Publicidad
English
Technical Information
Flow rate - showerhead
Flow rate - handshower
Installation Considerations
• For best results, Hansgrohe recommends that this
product be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• This showerhead is for use with automatically
compensating valves rated at 1.5 GPM
(5.7 L/min) or less.
• The Croma Select S Showerpipe Set may be
used to replace the showerhead in an existing
shower.
• It may be necessary to correct the
existing plumbing before the Croma
Select S Showerpipe Set can be installed.
• This product requires a standard ½"
shower arm (not included). For proper fit
of the Croma Select S Showerpipe Set, the arm
must extend 4" - 4¾" from the surface of the
finished wall.
Product Notes
• It is not possible to use the showerhead and the
handshower simultaneously.
• The diverter on the Croma Select S Showerpipe
Set does not turn the water off.
2
max. 2.0 GPM
max. 2.0 GPM
• Use the enclosed template to confirm that the
• Protection against backflow is provided by check
• To prevent scald injury, the maximum output
• Keep this booklet and the receipt (or other proof
shower arm is the correct length for successful
installation of this product.
valve.
temperature of the shower valve must be no
higher than 120°F. In Massachusetts, the
maximum output temperature can be no higher
than 112° F.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
This product is intended as a showerhead
support only. Do not hang other items
from the shower arm or wallbar.
Do not use this product as a grab bar.
Publicidad
