Drill Safety Warnings; Screwdriver Safety Warnings - Dexter 20VSD2-35RC.1A Manual De Instrucciones

FR FR

3. DRILL SAFETY WARNINGS

A. Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
ES ES
B. Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal
injury.
PT PT
C. Brace the tool properly before use. This tool produces a high output torque and without
properly bracing the tool during operation, loss of control may occur resulting in personal injury.
IT IT
D. Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring. Cutting accessory contacting a
EL EL
«live» wire may make exposed metal parts of the power tool «live» and could give the operator
an electric shock.
Safety instructions when using long drill bits
PL PL
A. Never operate at higher speed than the maximum speed rating of the drill bit. At
higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the workpiece,
RU RU
resulting in personal injury.
B. Always start drilling at low speed and with the bit tip in contact with the workpiece.
KZ UA
At higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
C. Apply pressure only in direct line with the bit and do not apply excessive pressure.
UA KZ
Bits can bend causing breakage or loss of control, resulting in personal injury.
RO RO
4. SCREWDRIVER SAFETY WARNING
Hold power tool by insulated gripping surfaces, when performing an operation where
BR BR
the fastener may contact hidden wiring.
Fasteners contacting a «live» wire may make exposed metal parts of the power tool «live» and
EN
EN
could give the operator an electric shock.
If possible, always use clamps or a vice to hold your work.
Ensure that the lighting is adequate.
Do not put pressure on the tool, such that it slows the motor down. Allow the bit to screw without
pressure. You will get better results and you will be taking better care of your tool.
Keep the area free of tripping hazards.
Only use accessory bits in good condition.
Do not touch the bit away after operation. It will be very hot.
Keep your hands away from under the workpiece.
Never use your hands to remove dust, chips or waste close by the bit.
Rags,cloths,cord,string and the like should never be left around the work area.
Support the workpiece properly.
looking up.
When using the tool, use safety equipment including safety glasses or shield. Hearing protection,
and protective clothing including safety gloves. Wear a dust mask if the operation creates dust.
244