Maintenance Instructions - TRAPP TR 500 Manual De Instrucciones

www.trapp.com.br
TR 500E / TR 500G
1. Loosen the motor fixing screws and nuts (1),
positioned on the base (2), so that the belts are
with the desired clearance, as shown in Figure 5.
1
2
Fig. 5
2. With the adjustment made, tighten the motor
fixing screws and nuts (1) always observing the
motor alignment, where the motor base must be
parallel with the machine base (2), also observing
the alignment of the motor pulleys with the
disc pulley. To check this alignment, a ruler or
something that serves as a ruler can be used,
where the two pulleys will be compared, touching
the ruler across the face of the motor pulley and
the other end of the ruler must be touching the
face of the disc pulley. The alignment will be
correct when the two ends of the ruler touching
the pulley faces evenly.
After use, clean the equipment residues.

In shredders with PTO 500T it is necessary to check

before use, if the 3 fixing points are blocked and if
the cardan shaft is fixed on the 2 tips of the TDP.
The equipment shall be on, with power outlet

disconnected from power supply, when servicing or
cleaning the shredder.
Image merely illustrative

Maintenance Instructions

TR 500T
1. Loosen the screws (1) that fix the transmission
box (2), just to loosen the box; you don't need to
remove these screws;
2. Loosen the nuts (3) and (4);
3. Tighten the screw (5) until the clearance in the
belts is ± 10 mm, as shown in Figure 6;
4. After adjusted the clearance, tighten the nuts (3)
and (4).
2
Fig. 6
Hammer replacement
Hammers installed in the disk can be used twice.

When one side of the hammer is worn, and

products are poorly shredded, turn hammers over as
described below:
1. Loosen the two hexagon nuts and remove service
opening protection (2).
2. Remove side cover (locking of square rods) (1).
3 4 5
1
Image merely illustrative
71