Zeiss Primo Star Instrucciones De Manejo página 6

Carl Zeiss
The microscope is equipped with a plug-in power unit allowing line voltages to be used in the
range between 100 and 240 V ± 10%, 50/60 Hz, without the need for changing the voltage
setting on the instrument.
The plug-in power unit meets the requirements of Protection Class II (with protective
insulation). If its casing is damaged, put the plug-in power unit out of operation. The
microscope may be operated only with the supplied plug-in power unit.
If it is determined that protection measures are no longer effective, the instrument must be
switched off and safeguarded against inadvertent operation. Please contact a Zeiss service
agency or the Carl Zeiss Microscopy Service to repair the instrument.
− Always disconnect the power cable, before opening the instrument and changing the lamp
or LED source.
− Wait for the lamp to cool down before replacing it and do not touch the new bulb.
− The instrument may only be opened by qualified specialists or service staff.
− The operation of the instrument in explosion-risk environments is not allowed.
Make sure to read the safety notes provided with Immersol 518 N
Immersion oil irritates the skin. Avoid any contact with skin, eyes and clothing.
After skin contact, wash the oil off with plenty of water and soap.
After eye contact, immediately rinse the eye with plenty of water for at least five minutes.
If the irritation persists, consult a specialist.
Proper disposal of immersion oil: Take care to ensure that immersion oil does not enter surface
water or the sewage system.
The microscope is not equipped with special devices for the protection from substances that
are corrosive, potentially infectious, toxic, radioactive, or other substances that could be
hazardous to health. Make sure to observe all legal regulations, particularly the relevant
national accident prevention regulations when handling such substances.
Before any transport of the instrument, switch it off and let it cool down (hot surface at the
−
bottom of the instrument).
− Operate the device only on a hard, non-combustible support.
− The plug-in power unit must not get in contact with moisture.
6
Notes on Instrument Safety Primo Star
®
immersion oil.
B 46-0071 v 03/06