USAG 076 F Manual Del Usuario página 29

Clean the terminals as follows:
1. Set the range switch to OFF position and remove the test leads from the meter.
2. Shake out any dirt which may exist in the terminals.
3. Soak a new swab with alcohol.
4. Work the swab around in every terminal.
Replacing the Battery and Fuse
Warning
Remove test leads from the meter before opening the back cover or the battery cover.
To replace the batteries, remove the screws on the battery cover and remove the battery cover, replace the exhausted batteries with new
batteries of the same type (AA or equivalent). Reinstall the battery cover and the screws.
fuse with a new one of the same ratings. Reinstall the back cover and all the screws.
APPENDIX
When the meter is not in use, you can wind the test leads around the meter, if necessary, by using the following procedure:
1. Insert the plug of the black test lead into the "COM" terminal and the plug of the red test lead into the " " terminal.
2. Wind the test leads anticlockwise around the meter.
3. Lay the test leads through the groove at the bottom side of ther meter (see the Bottom View) and then mount the tes lead probes
in the probe brackets.
Top View
Bottom View
Left View
Front View
Back View Right View
29