Rain Detection Sensor - GIESSE VARIA SLIM RADIO Manual De Uso

described in point 10.1.1 and you have the radio remote control which is already
recognized. To remotely save a radio remote control, follow the procedure below:
▪ Equip yourself with the RC radio remote control to be saved and set it on the
desired channel (see the instructions provided with the radio remote control).
▪ Equip yourself with the radio remote control already saved and operating on
the VARIA SLIM RADIO in question.
▪ On the already saved radio remote control, press the following buttons in
sequence: F1, F2 and then
VARIA SLIM RADIO (in the same way as pressing the PRG button).
▪ Within 10 seconds, press any one of the up arrow ▲,
buttons of the (new) radio remote control that you want to program two times
(once to activate the display of the radio remote control and the second time
to transmit the radio code).
10.2. Control with conventional button
If necessary, due to unavailability of the radio remote control or other reason, the
controls can be connected by cable.
The control must have a clean (voltage-fee) single-pole contact, normally open, or
a deadman's button, but not a stable switch. It should be connected to the left
terminal block in the actuator, as indicated in the previous "Electrical connection"
chapter.
Warning. The IN1 and IN2 controls prevail over the radio commands.
The manual control prevails over radio remote control.
10.3. Ventilation function
The commands issued by the radio remote control can include a specific function
called "V
ENTILATION
specified time.
To activate this function, press the following buttons in sequence: F1, F2, up
arrow ▲.
The window opens and, if no other commands are given, closes again
automatically after 5 minutes. In the case in which the rain sensor, a manual
command or radio command intervened, the ventilation function stops; to restore
the function, the sequence of buttons must be pressed again.

11. Rain detection sensor

The rain sensor should be installed outside on the window frame and fixed with a
screw or weather-resistant adhesive system. The device acts only on the
commands of the chain actuator.
Warning. The command coming from the rain sensor prevails over any other
command; if a stable switch is assembled with the manual control and forced
opening is instructed, after having reached the opening stroke-end the window
STOP
", which has the purpose of ventilating the room naturally for a
. This sequence "opens" the memory of the
38
or down arrow ▼
STOP