Preparation Of Actuator For Assembly - GIESSE VARIA SLIM RADIO Manual De Uso

Attention. The actuator at maximum charge, exercises a force enough to
crush fingers in the event of distraction.
After each closure or intervention of the electrical protection mechanism, the
chain moves in the opposite direction for around 1,0/1,5 mm. This is to loosen the
tension of the mechanical parts and gives correct pressure to the weather
stripping.
14. Assembly
These indications are intended for the attention of technicians and
specialized personnel. Basic job and safety techniques are therefore not
All preparatory operations, assembly and electrical connections must be carried
out by technical and specialized personnel to guarantee best performances and
good function of the VARIA SLIM RADIO chain operated actuator. First of all,
please check that the following fundamental points have been satisfied:
Before installing the actuator, check that the moving parts of the window on which
it is to be installed are in perfect working condition and that they open and close
properly and are well balanced (where applicable).
Check that the electrical supply used corresponds to the indications on the
"TECHNICAL DATA" label attached to the machine and that the given
temperature range is compatible with the place of installation.
Actuator specifications must be sufficient for movement of the window without
encountering any obstacle. The limits indicated in the technical data table must
not be superseded (page 7) and the most appropriate stroke should be selected.
Calculations should be checked using the formula indicated on page 5.
Ensure that the actuator has not been damaged during transport, first visually
and then by powering in both directions.
Check that the width of the inside of the window (where the actuator is to be
assembled) is over 405 mm, otherwise the actuator should not be installed.
Check that once the actuator has been installed the distance between the fixed
part of the window frame (where the actuator is to be assembled) and the
mobile part of the window frame (where the bracket is to be fixed) is greater
than or equal to 0 mm. If this is not the case the actuator will not function
correctly as the window will not close correctly. If required, add additional
thickness below the support brackets to reset the quota.

14.1. Preparation of actuator for assembly

Before starting assembly of the actuator, prepare the following material for
completion, equipment and tools.
For fixing onto metal window frames: M5 threaded inserts (6 pieces), M5x12
◆
flat headed metric screws (6 pieces).
For fixing onto wooden window frames: self-threading screws for wood Ø4.5 (6
◆
pieces).
included.
40