Mounting The Bar And Chain - Stihl HT 75 Manual De Instrucciones

English

Mounting the Bar and Chain

Removing the chain sprocket cover
Unscrew the nut and remove the
N
cover.
1
2
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot, then back it off 5
full turns.
54
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
Fit the chain – start at the bar nose.
N
5
1
4 3
Fit the guide bar over the screw (3)
N
and engage peg of tensioner slide in
the hole (4) – place the chain over
the sprocket (5) at the same time.
Turn the tensioning screw (1)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
Refit the cover and screw on the nut
N
fingertight.
Go to chapter on "Tensioning the
N
Saw Chain"
HT 75