Planeta BK Serie Instrucciones De Manejo página 7

Installation and Operation Manual for:
PLANETA Beam Clamp BR+BK
I. Beam Clamp BR+BK
Available in the following capacities:
Type
BK - 10
BK – 20
BK – 30
BK – 50
BK – 100
BR – 10
BR – 20
BR – 30
BR – 50
BR – 60-S
II. Important indications
1. Read instruction and make it available to operators on the device before using it.
2. Operator must be instructed properly with the device. Never leave the device under load
unattended!
3. Never exceed carrying capacity indicated on the name plate. Do not draw any pull and
lifting ropes or chains respectively over angles.
4. Do not transport persons or loads with the product over areas below which persons
could be staying.
5. Device must be checked once a year by a technical expert, in case of harder operating
conditions more often. Ask your retailer or PLANETA. The enterpriser is liable in case of
damages and has to provide test certificates.
6. Check the device regarding damages, unfastened screws or twists before using it and
eliminate failures.
7. Repair works on PLANETA hoisting devices shall only be carried out by the
manufacturer or an instructed repair shop respectively by using PLANETA spare parts.
8. Check load carrying constructions, load securing devices, mountings, cross beams etc.
regarding load carrying capacity and condition of the required loads by a technical
expert.
9. Non-observance of the instruction, improper use, and corrosion by insufficient protection
or product alterations without authority result in the expiry of the warranty.
10. Risk of corrosion in case of continuous contact with unfavourable atmospheric conditions
as for example high humidity or harmful environmental influences as for example
atmospheres with acid vapours, corrosive gases or high dust concentration cause early
wear. This effectuates no claim under warranty.
III. Security advices
1. Never use beam clamp unless securely fastened to girder or structure.
2. Always make sure beam, girder or structure is suitable for beam clamp and that safe
working load has been applied.
Capacity kg
1000
2000
3000
5000
10000
1000
2000
3000
5000
6000
– 7 –
GB
Flange width in mm
75-230
75-230
80-320
90-320
90-320
64-203
76-203
76-203
100-305
75-200