Frequently Asked Questions - Marmitek IR CONTROL PRO 8 Manual De Instrucciones

TIP:
• With the help of the supplied IR Extension cables 4 A/V devices can be controlled with
the IR Module, which is simply to be extended to maximal 8 A/V devices with the help of
one ore two optional obtainable IR Eyes. (2x IR Eye Art. Nr. 09682).
• With the help of an extra IR Receiver you can also control your A/V equipment from
another place (if desired you can extend the connection cable of the IR receiver.)
- built-in IR receiver Art. nr. 09733
- built-on IR receiver Art. nr. 09734
STATUS CONNECTION (Power adapter not supplied)
You can send a Power Status signal to the IR module by connecting a Power adapter to this
connection (not supplied; 12VDC/200mA), which is switched by the device to be controlled.
When the A/V device or contact is switched in a LED will light up in the IR receiver and the IR
Module so that you can see that the A/V device is switched in. (see picture 3).

4. FREQUENTLY ASKED QUESTIONS

The IR Receiver does not respond to signals of my remote control.
Observe the following directions:
• Check the connections, is the power adapter connected to the correct connection? This
must be connected to the 'POWER' connection, the green lamp will burn when the
power adapter is plugged in the plug.
• Both the built-in and the built-on IR Receiver has a reception sensibility of about 10
metres at an opening Angle of 90 degrees. Range is also dependent on the remote
control used. The IR reception indication LED in the IR Receiver will light up at reception
of an IR signal.
6
Power adapter 12V/200mA (optional)
V+
G
ST
IR
Circuit power on back
of A/V equipment
230V/50Hz
1
2
3
4
Picture 3
© MARMITEK