Publicidad
Operating panel
GB
A Display
B Feed button
C Online button
D Cut button
E Prog button
The AP 5.4 has three different operating
modes: offline, online and report mode. The
display [A] shows the active operation mode.
After powering-on, the printer is in online
mode.
Display messages are quoted here in the
national language, if it is provided by the prin-
ter (otherwise in english). Refer to chapter 5
to learn how to change the language setting.
Online
The printer is ready to receive data. Print jobs
sent to the printer will be printed immediately.
One of the following display messages may
appear:
ONLINE 0 JOBS
ONLINE 0. JOBS
generated (--> point beside the 0).
ONLINE 3 JOBS
Restcount
labels to print.
ONLINE 3 JOBS
Stopped
print. Continue by pressing Feed.
Print contrast
75%
pressing Prog).
Press Online to switch between online and
offline mode!
Offline
The following pictograms show the buttons,
which have to be pressed (left side) and the
display after pressing those buttons (right
side). The pressed buttons are marked black.
OFFLINE 0 JOBS
Slow feeding of label material and ribbon:
Online
Feed
The printer is waiting for
print jobs.
A print job is being sent;
the print image is being
3 jobs are loaded, the first
of which is just being pro-
25
ceeded. There are still 25
A print job has been stop-
ped (by pressing Online).
25
There are still 25 labels to
Energy supply of the print
head: 75% of the maxi-
mum level (activated by
The printer is initially swit-
ched offline
OFFLINE 0 JOBS
feeding...
Feeding of label material:
Feed
Cut (if a cutter is mounted):
Cut
Access to the parameter menu:
Prog
Restarting the printer:
Cut
Online
Feed
User manual AP 5.4, topic section „Commis-
sioning and Operation", chapter „Operation in
CD
offline mode".
Report mode
Status no.:
5001
No gap found
Acknowledge status messages by pressing
Online!
The most important status messages:
(M: = measure)
5001: No punch detected. M: Check the ma-
terial settings; Clean the punch sensor;
Check the position of the punch sensor.
5008: Ribbon end. M: Insert a new ribbon roll.
5002: Material end. M: Insert new ribbon;
Check the position of the material guiding.
5005: Cutter fault (if mounted). M: Check the
cutter sensor; Clean the cutter blades.
Only dispenser version printers:
5063: The locking lever at the backing paper
feed roller is opened. M: Close locking lever.
5064: The diameter of the rewinded backing
paper roll is too high. M: Clear the rewinder.
User manual AP 5.4, topic section „Status
reports".
CD
OFFLINE 0 JOBS
feeding...
OFFLINE 0 JOBS
cutting...
PRINT INFO
System start...
Status messages consist
of a status number and a
short description.
85
Publicidad
