MELICONI Logic 12 Manual De Instrucciones página 32

5. At this point, press the LEARN button together
with the button where you want to carry out the
association of the acquisition. In the top left hand
part of the screen the writing "LEARN" will
appear and, when you release the two buttons,
the green light will come on.
6. Within 10 seconds, press the button on the
original remote control and keep it pressed
down until the green light goes out and when the
"STOP" appears in the top part of the LCD.
After it goes off, the green light can be turned
on again and in the top part of the LCD will
appear the writing "AGAIN": in this case, you
need to press the same button on the original
remote control again until the green light turns
off again.
7. The procedure will only be successful when the
screen shows the writing "END".
After it goes off, the red LED flashes three times,
confirming that the signal has been picked up.
Only then will the remote control be ready to
pick up other signals to associate with other
buttons.
Learn all the functions of a new remote control
B
The LOGIC12 has 6 completely empty codes, that can be called up as you wish and
can be fully personalised via the LEARN function up to an
1. Programme an appliance selection button with one of the following codes: 8000, 8100, 8200,
8300, 8400 or 8500.
2. For the programming, follow the instructions shown in the FAST PROGRAMMING paragraph on the
remote control.
3. In order to acquire and store the signals coming from one or more original remote controls, follow the
A
procedure.
The MEMO function allows us to store command sequences on a single button (called "launch button"),
that can be activated by simply pressing on it. This function was conceived to simplify the daily use
of the remote control if the users find themselves regularly repeating complex operations, that for
example, cause repeated commutation between different appliances.
The maximum number of sequences that can be stored is 85 and for each sequence you can store up
to a maximum of 31 button pressings. The launch buttons in a sequence can be all the normal buttons
on the remote control, with the exception of the USE, PAGE, LEARN and LIGHT buttons.
In order to start recording:
1. Firstly, select the appliance required (press the
USE button and then the button relative to the
appliance).
2. Press the USE button for 5 seconds. The red
LED at the top starts flashing, indicating that
the remote control is at the programming stage.
On the screen in the top right hand corner, the
symbol C appears followed by 3 underscores.
Type in the code 999.
30
not yet installed in the LOGIC12 database
overall maximum of 85 new commands.
MEMO FUNCTION
(e.g. LEARN + 1 User
Display button)
USE
5 SEC.