Manual Programming - MELICONI Logic 12 Manual De Instrucciones

Connect to the www.logicmeliconi.com address where you will be able to quickly find the
appliance's specific code with which to programme the remote control. Once you have obtained the
code corresponding to the appliance that you wish to control, continue as follows:
1. Lightly press the USE button to access the device
selection display. The red LED starts flashing. So,
keep the selection button that corresponds with
the appliance where you want to insert the code
(eg. TV 1), pressed down for 5 seconds. This way
you can access the code programming display.
2. Insert the previously identified specific code
(e.g: 1274) using the numerical buttons on
the screen. Three flashes in succession
indicate that the
completed. The inserted number will be
displayed in the top right part of the screen.
If the code is refused, or if you want to perform a guided personalisation, you have to load the code
via the PC connection, following the instructions found on the website
If you do not have Internet access, you can programme
1. Turn on the appliance that you want to control.
- If TV, SAT, TER, PAY or CABLE select a
programme
- If VCR insert a tape in the stop position
- If DVD insert a DVD in the stop position.
2. Lightly press the USE button to access the
devices' display. The red LED starts flashing.
Press the button corresponding to the device
that you want to find the code for (eg. TV 1).
This way you will access the programming
display.
3. Press the button corresponding to the writing
SEARCH in the lower right hand corner of the
screen. The red LED above is flashing faster.
4. Point the remote control at the appliance. On
the new research display, press the ON/OFF
or PLAY for VCR and DVD, stopping when the
appliance responds properly to the command
sent.
5. At this point, press the button corresponding to
the writing OK in the lower right hand corner of
the screen to confirm the choice. Three flashes
on the red LED indicate that the research
operation has been completed, and the screen
moves to normal functioning. In the top right
hand corner the stored code is legible, while the
rest of the screen reproduces the symbols of
the functions foreseen in the first of the three
available pages.
FAST PROGRAMMING
operation has been
www.logicmeliconi.com.

MANUAL PROGRAMMING

the remote control manually as follows:
USE
(e.g. TV 1)
USE
(e.g. TV 1)
SEARCH
OR
27