Problem Solving - MELICONI Logic 12 Manual De Instrucciones

4. Within a few seconds, keep the button pressed
down that corresponds to the area of the screen
where you want to transfer the writing. If you
wish, it is possible to go to another of the pages
that can be viewed on the screen, by pressing
the PAGE button. A triple flash of the red LED will
confirm the storage and transfer of the writing in
the selected area.
If, during insertion, you press the BACK button <-, it deletes the previous digit and starts a new
insertion.
You can also overwrite writing on the buttons that do not have any yet. If the selected button does
not correspond with any function, the writing will not be stored by the remote control.
If the need should arise to completely reset the user settings on the remote control - that is, delete
all the LEARN commands, all the additional sequences and functions stored, as well as all the text
acronyms and return to the standard configuration, proceed as follows:
1. Select any appliance from the device selection page
2. Type in the 9001 code following the procedure described in the FAST PROGRAMMING paragraph
on the remote control. Three flashes indicates that the operation has been completed successfully.
3. Repeat the operation by typing in the code 9000.
PROBLEM
The appliance to be controlled is not responding,
the red LED on the remote control is not coming
on and the LCD screen has not come on when a
button is pressed.
The appliance does not reply, the red LED does
not come on nor does the screen.
The appliance does not respond but the red LED
at the top is on.
The remote control is not carrying out all the
commands properly.
If you have any questions regarding the new LOGIC12 remote control:
• Read this Instruction Manual carefully and this will help you find an answer to
most of your questions
• Visit our dedicated Internet site www.logicmeliconi.com where you will find all the answers
you need
The symbol of a bin crossed out on the appliance indicates that the product at the end of its life cycle should be disposed of separately from other
refuse. The user will, therefore, have to hand over the appliance at the end of its life cycle to a proper recycling centre for electronic and electrotechnical
refuse, or give it over to the seller when they buy a new, similar appliance, on a one for one basis. Proper separate refuse collecting for the later initia-
tion of the appliance sent for recycling, treatment and environmentally friendly disposal, contributes to reducing negative effects on the environment
and on our health and encourages the recycling of the material used to make the appliance.
32
NOTES:
DELETING THE USER SETTINGS

PROBLEM SOLVING

SOLUTION
Check that the batteries are inserted properly and
are perfectly loaded. If necessary, replace them.
Check and see if the writing LOW BAT appears in
the top right hand corner of the screen. If this is
the case, replace the dead batteries.
Make sure that there are no obstacles between
the remote control and the appliance to be
controlled. Furthermore, make sure you have
selected the appliance to be controlled. If
necessary, reset the remote control code,
repeating the programming procedure.
Perhaps you are using an incorrect code. Reset
the remote control by repeating the programming
procedure.
INFO-LINE