Repairs - Spare Parts; Warranty Conditions - Lavorwash NPX XP Manual De Instrucciones

Fault Water is not hot enough
Cause • Poor boiler performance.
• Boiler coil clogged with limestone.
Re-
• Clean burner nozzle filter.
pair • Clean fuel filter.
• Check diesel pump pressure.
• Descaling.
Fault Too much smoke from the chimney
Cause • Combustion is not correct.
• Impurities or water in the fuel.
Re-
• Clean fuel filter.
pair • Clean the boiler.
• Empty the tank and clean it carefully.
• Clean fuel filter as well.
Fault Insufficient detergent suction
Cause • No detergent in the tank.
• Incrusted injector.
• Either coil or tube or lance are clogged.
Re- • Fill the detergent tank.
pair
• Clean it.
• Either cleaning or descaling.
> REPAIRS - SPARE PARTS
For any problems not mentioned in this manual, or if
the machine breaks down, you are urged to contact
an Authorized After-Sales Service for the relative
repair or for any replacement of components with
original spare parts. Use exclusively original replace-
ment parts.
> WARRANTY CONDITIONS
All our machines are subjected to strict tests and are
covered against manufacturing defects in accordance
with applicable regulations (minimum 12 months). The
warranty is effective from the date of purchase. If your
high pressure washer or accessories are handed in for
repair, a copy of the receipt must be enclosed.
Guarantee repairs are being made on the following
conditions: - That defects are attributable to flaws or
defects in materials or workmanship. - That the direc-
tions of this instruction manual have been thoroughly
observed. - That repair has not been carried out or at-
tempted by other than authorized service staff. - That
only original accessories have been applied. - That the
product has not been exposed to abuse such as knocks,
bumps or frost. - That only water without any impuri-
ties has been used. - That the high pressure washer has
not been used for rental nor used commercially in any
other way.
The following are not included in the warranty: -
Parts subject to normal wear. - The high-pressure tube
and optional accessories. - Accidental damage, caused
by transport, neglect or inadequate treatment, incor-
rect or improper use and installation failing to comply
with the indications in the instruction manual. - The
warranty shall not cover any cleaning operations to
which the operative components may be subjected.
Repairs under this guarantee include replacement of
defective parts, exclusive of packing and postage/car-
riage. The warranty shall not cover replacement of the
machine or extension of the guarantee resulting from a
breakdown. The manufacturer declines all responsibi-
lity for damage to persons or property caused by bad
installation or incorrect use of the machine.
WARNING! Failures, such as clogged nozzles, valves
and mechanism blocked due to limestones, damaged
pressure cleaner accessories (like kinked high pressure
hose) and/or appliances normally working without any
defects ARE NOT COVERED BY THE WARRANTY.
> DISPOSAL
As the owner of electrical or electronic equip-
ment, the law (in accordance with the EU Directi-
ve 2002/96/EC of 27 January 2003 on waste from
electrical and electronic equipment and the na-
tional laws of the EU Member States that have implemen-
ted this Directive) prohibits you from disposing of this pro-
duct or its electrical / electronic accessories as municipal
solid waste and obliges you to make use of the appropriate
waste collection facilities.
The product can be disposed of by returning it to the distri-
butor when a new product is purchased. The new product
must be equivalent to that being disposed of.
Disposing of the product in the environment can cause
great harm to the environment itself and human health.
The symbol in the figure indicates the urban waste con-
tainers and it is strictly prohibited to dispose of the equi-
pment in these containers. Non-compliance with the re-
gulations stipulated in the Directive 2002/96/EC and the
decrees implemented in the various EU Member States is
administratively punishable.
EN
25