Spark Plug; Idle Speed - Honda GX200 Manual Del Propietário

Ocultar thumbs Ver también para GX200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 37
3RZ1C8000.fm Page 9 Friday, April 13, 2018 9:19 AM

SPARK PLUG

Recommended Spark Plugs: GX200:BPR6ES-5 (NGK)
GX390:BP6ES (NGK)
The recommended spark plug has the correct heat range for normal
engine operating temperatures.
An incorrect spark plug can cause engine damage.
If the engine has been running, let it cool before servicing the spark
plug.
For good performance, the spark plug must be properly gapped and
free of deposits.
1. Disconnect the spark plug cap,
and remove any dirt from
around the spark plug area.
2. Remove the spark plug with a
spark plug wrench.
3. Inspect the spark plug.
Replace it if damaged or badly
fouled, if the sealing washer is
in poor condition, or if the
electrode is worn.
4. Measure the spark plug
electrode gap with a wire-type
feeler gauge. Correct the gap,
if necessary, by carefully
bending the side electrode.
The gap should be:
GX200:0.4–0.5 mm
(0.016–0.020 in)
GX390:0.7–0.8 mm
(0.028–0.031 in)
5. Install the spark plug carefully, by hand, to avoid
cross-threading.
6. After the spark plug is seated, tighten with a spark plug wrench
to compress the sealing washer.
When installing a new spark plug, tighten 1/2 turn after the
spark plug seats to compress the washer.
When reinstalling the original spark plug, tighten 1/8–1/4 turn
after the spark plug seats to compress the washer.
TORQUE: 18 N∙m (1.8 kgf∙m, 13 lbf∙ft)
A loose spark plug can overheat and damage the engine.
Overtightening the spark plug can damage the threads in the
cylinder head.
7. Attach the spark plug cap to the spark plug.
SPARK PLUG WRENCH
SIDE ELECTRODE
GX200:0.4–0.5 mm
(0.016–0.020 in)
GX390:0.7–0.8 mm
(0.028–0.031 in)
SEALING
WASHER
ENGLISH

IDLE SPEED

Adjustment
1. Start the engine outdoors,
and allow it to warm up to
operating temperature.
2. Move the throttle lever to
its minimum position.
3. Turn the throttle stop screw
to obtain the standard idle
speed.
Standard idle speed: GX200 : 1,400 +200 min
GX390 : 1,400 ±150 min
THROTTLE STOP SCREW
-1
(rpm)
-1
–150 min
(rpm)
-1
(rpm)
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gx390

Tabla de contenido