Filter Maintenance; Replacing The Filter - IPC Gansow 1010 S Manual De Instrucciones

7.3 - FILTER MAINTENANCE

The filter is a component of primary importance for the correct work
of the machine.Its correct maintenance will keep the functioning of
the machine always to the highest levels.
The filter can be cleaned in two ways:
1 - The electric filter shaker
This instrument is simple to use and allows you to keep the filter
in perfect working order. To operate the shaker, push down the
switch (7, fig. 3) and hold it down for a few seconds. Repeat the
operation 4 or 5 times.Remember that the cleaner the filter, the
better the results.This operation should be carried out after every
work cycle.
DUSTY ENVIRONMENT:If you are using the
machine in a particularly dusty environment ( i.e.
warehouses with trucks passing, sawmills,
ecc..remember that the filtershaker should be used
more frequently.
2.
In the case in which the cleaning of the filter by the filter-shaker
wouldn't be effective,and every 20 working hours anyway,proceed
with the manual cleaning of the filter.
Before carrying out every operation on the machine,make sure that
this last be switched off and that all of its functions be disactivated,to
get to this state, set the key switch 5 Fig.3 in the OFF position.
In order to attain to a more thorourg cleaning it is advised to proceed
a follows in addition to the use of the filter-shaker:
1 - Lift the bonnet where the seat is located.
2 - Slacken the wing nut on the filter box cover.
3 - Remove the cover.
Clean the filter blowing with a jet of compressed air directed
towards the waste bin, so that any residual falls into the bin.

7.4 - REPLACING THE FILTER

Every 200 hours of work, the filter must be replaced. To do so:
1 - Lift the bonnet where the seat is located.
2 - Slacken the wing nut on the filter box cover.
3 - Remove the cover.
4- Loosen the 4 locking rings
5- Loosen the 4 knobs
6 - Remove the filter from the filter holder.
After replacing the filter, carry out the above operations
in reverse order.
7- Unscrew the four screws (Pocket filter).
8 - Disconnect the connector on the filter shaker (Pocket filter).
9 - Remove the filter from its housing (Pocket filter).
10 - Thoroughly clean the filter with a vacuum cleaner or replace it
(Pocket filter).
After replacing the filter, carry out the above operations
in reverse order.
ENGLISH (Translation of original instructions)
Cleaning the filter manually
Place the filter as indicated on the label
stuck on the same filter.
When fastening the filter,make sure that filter and
gaskets are tightproof.
WARNING:To get rid of the filter, follow strictly the
directing laws.
7.5 - DEAD POINT ADJUSTMENT
Should the machine move also when the selection pedal4 Fig.2 is
not pressed, adjust the dead point as follows:
- Unscrew the counternut 1 placed nearthe coupling clip.
- Adjust by means of the screw 2 until you don't find the advancing
point.
- Screw the blocking counternut 1 up.
Panel filter
Pocket filter
Pag. 8