Safety Instructions - Ega Master 79623 Manual De Instrucciones

Any tool can be dangerous.
Please follow these simple procedures.
They are for your protection.
Follow the general current and appropriate Accident Prevention and Safety Procedures.
Never work under the influence of alcohol, drugs or stronger medication.
Keep your working area clean and uncluttered.
Keep children away.
Switch off the machine if it stops - for any reason - to avoid the unexpected starting in
uncontrolled condition.
Unplug power supply and check, if the switch is off, when the machine is in an uncontrolled
condition, during assembly and disassembly and when adjusting resp. fitting an accessory part.
Do not operate the tool if it is damaged, improperly adjusted or not completely and correctly
assembled.
Before every use check the machine, cable and plug. Damages have to be eliminated by an
authorised specialist only. Take care that the machine is switched off when the plug is inserted into
a power receptacle.
Fans installed in the open or vertically should be equipped with a rain protection roof. Please be
informed that the user only is responsible for the installation of the fan.
Do not touch the cable, if the power supply line is damaged during work.
Immediately disconnect power supply. Never apply a machine with defective power supply line.
Always consider the reaction moment of the machine.
Do not touch rotating parts.
Always switch off the motor disconnect power before transport.
Check damaged parts. Before using the machine, damaged parts or protective devices should
be carefully checked to make sure they work soundly and fulfil the designated function. Check
alignment, connections and attachment of moving parts. Also check if parts are broken. Parts
or protective devices that are damaged should, if nothing else is mentioned in these operating
instructions, only be exchanged or repaired by qualified personnel. The same applies to defective
switches and valve triggers. If the machine cannot be switched on or off with the valve trigger, it
should not be used.
Only operate the tool after a thorough training or under supervision of a trainer.
Follow the valid national provisions in the country of application.

SAFETY INSTRUCTIONS

11