Pre-Installation; Tools Required - AquaPRO 63043 Manual Del Propietário

PRE-INSTALLATION

APPLICATION
This unit is a convertible jet pump designed for pumping water where the water is located less than 70 feet. If the water level
to the pump is deeper than 70 feet, a deep well submersible pump should be selected. A pressure switch pre-set at 30 psi
"on"/50 psi "off" has been installed on the pump. The pressure switch can automatically turn on and off the pump based on
the system pressure.

TOOLS REQUIRED

Flathead
Screwdriver
Safety goggles
SPECIFICATIONS
POWER SUPPLY
LIQUID TEMP. RANGE
DISCHARGE
SUCTION
SHALLOW WELL WATER LEVEL
DEEP WELL WATER LEVEL
Phillips
Screwdriver
Tape Measure
115V/230V,60HZ,20/10Amp circuit
32° F to 77° F (0° - 25° C)
1in. FNPT
1 1/4FNPT
25 ft.
70 ft.
3
Pipe wrench
Thread Tape
Hacksaw
PVC glue