Tool Specifications - DeWalt DW325PT Manual De Instrucciones

Tool Specifications

Model
heIGht
WIdth
lenGth
WeIGht
MaGazIne anGle
recoMMended
oPeratInG Pressure
aIr consuMPtIon Per
100 cycles
loadInG caPacIty
nail Specifications
Model
naIl lenGths
shank dIaMeters
Fastener collatIon 30° - 34°
naIl tyPe
9R208191_DW325PL_DW325PT_DEWALT, FRAMING NAILER(LPF).indd 6
dW325Pt dW325Pl
12.5" (305 mm) 12.5" (305 mm)
4.75" (121 mm) 4.75" (121 mm)
17.5" (444 mm) 17.5" (444 mm)
7.6 lb (3.45 kg) 7.6 lb (3.45 kg)
30° 21°
70 - 120 psig 70 - 120 psig
7.5 cfm @ 80 psi 7.5 cfm @ 80 psi
Up to 92 Nails Up to 64 Nails
dW325Pt dW325Pl
2" - 3-1/4" 2" - 3-1/4"
(50 mm - 83 mm) (50 mm - 83 mm)
.113" - .131" .113" - .148"
(2.8 mm - 3.3 mm) (2.8 mm - 3.7 mm)
21° Plastic
Paper tape collated
30° clipped head/ 21° round head
30° full head
operATion
preparing the Tool (fig. 2, 3)
WarnInG: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection
when operating this tool. Keep the nailer pointed away from yourself
and others. For safe operation, complete the following procedures
and checks before each use of the nailer.
1. Before you use the nailer, be sure that the compressor tanks
have been properly drained.
2. Lubricate the tool following these directions:
a. Use D WALT pneumatic tool oil or a non-detergent S.A.E. 20
e
weight oil. Do not use detergent oil or additives as they will
damage o-rings and rubber parts.
b. Use a filter-regulator-lubricator in the air line between the
compressor and the tool when possible.
c. If a lubricator is not available, add 5 to 10 drops of oil in the air
fitting a least twice a day or every 4 hours of use.
FIG. 2
6
FIG. 3
11/14/14 3:06 PM