Electrical Connection - Faber Look Isola Manual De Instrucciones

Fitting the Panel and Fixing the Hood Canopy
Before fixing the Hood Canopy to the Frame:
•
Unscrew the screws near the Air outlet and use these
for attaching the Control Group 50;
• Remove the Grease filters from the Hood Canopy;
• Remove any Activated charcoal filters.
• Working from below, fix the Hood canopy to the
Frame provided, using the 4 screws 12f (M6 x 10)
provided.
• Then hook the upper part of the Panel 3, adjusted to
size, to the rubber supports in the upper part and in
the lower part of the Frame.
• Slide the lower part of the Panel 3 until its metal tabs
slot into the slots in the frame.

ELECTRICAL CONNECTION

• Connect the Hood to the Mains Power Supply, insert-
ing a bipolar switch with a contact aperture of at least
3 mm.
• Make sure that the Power cable has been properly
inserted into the Control Board Unit socket.
• Connect up all the connectors to the sockets provided
on the Control Board Unit, making sure they are
compatible.
EN
1
13
3