Electrical Connection - Blanco BC CH 4200 Manual De Uso

LEVELLING
To carry out this operation, proceed as follows.
1 - Unscrew the nut (A).
2 - Adjust the feet (B) to level the appliance.
3 - Tighten the nut (A).

ELECTRICAL CONNECTION

Important
The connection must be made by authorised,
skilled personnel, in accordance with
the relevant legal requirements, using
appropriate and specified materials. The
appliance is supplied with operating
voltage 400V/3N,
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
IT
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
GB
breaker close to the appliance.
2 - Undo the screws (B) of the terminal board sup-
port (C).
DE
FR
ES
A
English
F
3 - Connect the circuit-breaker (A) to the terminal
board (D), passing the cable through the appli-
ance's cable gland (E) as shown in the diagram
and in the electrical system diagram at the back of
the manual.
Use a flexible cable with at least type H07RN-F
characteristics, rated for an operating tempera-
ture of at least 80°C.
– Power supply cable gauge ≥ 2,5 mmq.
Important
When connecting, take care to connect the
neutral and earth lines and the ground ter-
minal line (F).
4 - Tighten the cable gland (G).
5 - Replace the terminal board support (C) on com-
pletion of the operation.
G
C
B
- 14 -
A
B
E
D