Step 6. Replacing The Access Cover - Samsung NY58J9850WS Usuario, Manual De Instalación

Ground strap
Ground plate
Black
White
Wire tips
White
Black

Step 6. Replacing the access cover

Replace the access cover on the range back. To replace the wire cover, insert double
projections in the pockets located below the opening and tighten the screw.
Red
Neutral
terminal
Red
Ground wire
(Green)
1. Loosen the 3 lower terminal screws from
the terminal block. Remove the ground
screw and ground plate and retain them.
2. Cut and discard the ground strap. Do not
discard any screws.
3. Insert the ground bare wire tip between
the range frame and the ground plate
(removed earlier) and secure it in place
with the ground screw (removed earlier).
4. Insert the bare wire (white/neutral) tip
through the bottom center of the terminal
block opening.
5. Insert the two side bare wire tips into the
lower left and the lower right terminal
block openings.
6. Tighten the screws until the wire is firmly
secured (35 to 50 inch-lbs.). Do not over-
tighten the screws since it could damage
the wires.
7. Go to step 6 and proceed with the
installation.
English 35