Setting Up The Machine; Adjusting The Stripping Grade; Performing A Stripping Test - Weidmuller Crimpfix E Manual De Instrucciones

5

Setting up the machine

The machine has to be set up in the following situations:
– If a different type of wire-end ferrule has to be pro-
cessed
– Every time the machine is put into operation
During set-up, the following settings must be checked
and adjusted if necessary:
– Start position symbol
– Stripping grade; wire cross section
– Crimping drum
– Day counter
To set the machine up, it must be in
the start position, and the start position symbol
must be displayed.
Basic menu display
A
Crimping die size
B
Stripping grade
C
Wire cross section
D Day counter
E
Start position symbol
Stripping grade adjustment value overview
Figure 5.1 Adjustment values
36
5.1 Adjusting the stripping grade
Required tool: Allen key size 4.
– The stripping grade (B) and the wire cross section (C)
are shown on the touch display.
– By turning in a clockwise/anti-clockwise direction, the
stripping grade is altered.
A
B / C
Figure 5.2 Stripping grade adjustment
D E
5.2 Performing a stripping test
Each time the material to be processed is changed, a strip-
ping test must be conducted.
► Switch on the mains switch.
► There must be no more wire-end ferrules in the trans-
port unit.
► Insert a wire for stripping.
► Check the result:
– Is all the stranded wire undamaged?
– Has stripping been performed straight and evenly?
► Change the stripping grade if the result is unsatisfac-
tory and repeat the test.
2516390000/03/07.2018