Reset The Day's Piece Quantity; Service Counter; Service Display - Weidmuller Crimpfix E Manual De Instrucciones

Operating the machine

6.5 Reset the day's piece quantity

► Switch to the counter menu.
► Press the touch display 3 s.
Day number is set to zero.
► Briefly press the touch display
Return to start menu.

6.6 Service counter

+1 200 002
+ 1
Service: - 1
C E
 
The total counter counts the work cycles during the entire
lifetime of the machine.
The service interval of the machine is 200,000 work cycles.
The service counter counts down instead of up; starting at
200,000.
Once 200,000 work cycles have been completed, the ser-
vice counter stands at 0. When the machine is next started,
the service notification is displayed (see section 6.6). The
service counter counts up again. The negative prefix sign
indicates that a counting cycle has been completed. The
service technician resets the service counter to 200,000.

6.7 Service display

Ready Device is ready for operation
––– Service ––– Service display appears after every
200,000 work cycles..
Step:: 2/0
C E
 
When the machine is switched on, the service display
flashes. The notification is acknowledged by tapping on the
display briefly one time. The machine is ready for operation.
40
Total counter: Number of
completed work cycles.
Day counter
Prefix sign and service coun-
ter
To maintain the machine's performance capability
for as long as possible, you should keep to the ser-
vice intervals specified.
– Small service after 200,000 work cycles
– Big service after 400,000 work cycles
Refer to the Weidmüller representative responsible
for your country.
Switching off the machine
► Switch the machine off.
When you finish the work, you should empty the
waste container and put it back into the machine
(see section 7.4).
Menu note
The machine boasts more menus and displays on the touch
display (figure 3.3, 4) which can be used for troubleshooting.
See section 8.
2516390000/03/07.2018