Angelcare AC601 Manual Del Propietário página 13

Ocultar thumbs Ver también para AC601:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Tips For Using Your Monitor
• When the monitor is in use, do not use a crib mobile or other crib accessories that may produce vibrations.
Other sources of vibrations may include fans, washing machines, loud music, etc. These sources of vibration
may interfere with the performance of your Angelcare® monitor and the alarm will not sound if it continues
to detect any movement. Be sure all vibration sources are eliminated before using the monitor.
• There are several reasons you may experience false alarms. The most common reason is the Nursery Unit
has not been turned off after you have removed your baby from the crib. Another reason is the Sensor Pad has
not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, hard surface with the
printed side facing up. The sensitivity level may also need to be adjusted. Refer to the Movement Sensitivity
Adjustment section.
• Your monitor can be used in any crib that is stationary and designed to safely hold a baby. Make sure there
is no bedding between the mattress and the Sensor Pad. The Sensor Pad must rest on a completely flat and
firm surface. If the crib has a spring or slat base, place a hard board between the crib base and the Sensor
Pad measuring at least 13" x 13" (33x33 cm) and 1/4 inch (6 mm) thick. Only use your Angelcare® monitor
in a stationary sleeping environment such as a crib where the Sensor Pad can rest on a hard, flat surface.
• Please note the difference between the Low Battery Indicator and the Alarm Indicator. The low battery indi-
cator is a rapid ticking sound on the Parent Unit and the green low battery indicator light slowly flashes. The
Alarm Indicator is a loud beeping sound and the green alarm indicator light flashes rapidly.
• When unplugging the AC adapter from each unit, be sure the unit is switched to the off position. If it isn't,
the unit will revert to battery mode if batteries are installed.
• You can use rechargeable batteries in the Nursery Unit, however, a rechargeable battery cannot be recharged
by plugging in the AC adapter. Remove batteries from the unit to recharge.
• The range of this monitor is approximately 820 feet (250 meters). However, the range will vary depending
on the surroundings. Test the range before use.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido