Angelcare AC601 Manual Del Propietário página 9

Setting Up Your Monitor
SENSOR PAD (See figs. 1 and 2)
Place the Sensor Pad under the center of the crib mattress with the printed side facing up. Make sure there is NO bedding
between the mattress and the Sensor Pad. The Sensor Pad must rest on a completely flat and firm surface. If the crib
has a spring or slat base, place a hard board between the crib base and the Sensor Pad measuring at least 13" x
13" (33x33 cm) and 1/4 inch (6 mm) thick. If your crib has a plywood base, your mattress support is firm enough to use the
monitor properly. Only use your Angelcare® monitor in a stationary sleeping environment such as a crib where the Sensor Pad
can rest on a flat, firm surface. Be sure to place the printed side of the Sensor Pad facing up. Now plug the Sensor Pad cord into
the jack on the back of the Nursery Unit marked "Sensor Pad". Secure the sensor pad cord to crib using a tie wrap. Run the cord
on the floor to ensure it is out of the baby's reach.Turn the Nursery Unit on using the switch on the left. The green Power Indicator
will light up. NOTE : The Sensor Pad works with all baby bed sizes and all mattresses, except memory foam mattresses or mat-
tresses with a hollow frame. You will need to test your Sensor Pad after the set-up is completed. Once you are done using the
Sensor Pad, please remove it from the baby's crib and store it away.The Angelcare movement monitor is not designed for use with
adults, children or infants older than 24 months.
Figure 1
PLACEMENT OF SENSOR PAD CORD
CORRECT
Sensor Pad
Crib Base
SELECT YOUR DETECTION MODE
On the right of the Nursery Unit select one of the following three functions by moving the wing upwards or
downwards:
• Sound & Movement: You will be able to hear your baby's sounds and see sound lights. Your baby's
movements are monitored and you will hear a "Tic" with every movement your baby makes. If no
movement is detected, the "Tic" sound will stop and after 20 seconds the alarm will sound.
• Tic Off: In this mode you will still hear your baby's sounds and see sound lights, and your baby's movement
is still being detected, but no "Tic" sound will be heard. If no movement is detected after 20 seconds the
alarm will sound.
• Sound Only: The Movement Sensor is disabled but you will still be able to hear your baby's sounds and
see sound lights. Your Angelcare® works like a regular sound monitor when set to "Sound Only".
WARNING
STRANGULATION HAZARD - Children have STRANGLED in cords. Keep the adapter cords and sen-
sor pad cord out of the reach of children. Do not put the Nursery Unit inside a crib or play yard.
Because of the serious strangulation risk to infants and toddlers, parents and caregivers should
never place the nursery unit within 3 feet (1 meter) of a crib. NEVER use extension cords with AC
adapters. ONLY use the AC adapters provided.
IMPORTANT
Keep at
least 1m
(39 inches)
apart
Remove mattress from the crib.
Place a Hard Board in the cen-
ter base of the crib, right under
the Sensor Pad(s).
Place Sensor Pad(s) on top of
Hard Board PRINTED SIDE UP.
Put mattress back in crib.
INCORRECT
Sensor Pad
1 Sensor Pad
Crib Center
The Sensor Pad works with most cribs and mattresses,
except memory foam and hollow frame mattresses.
9
2 Sensor Pads
Crib Center