Angelcare AC601 Manual Del Propietário página 6

20) Antenna -The antenna used for this transmitter
must be installed to provide a separation distance of
at least 20 cm (7.9") from all persons and must not
be collocated or operating in conjunction with any
other antenna or transmitter.
21) Power Lines- An outside antenna system should
NOT be located in the vicinity of overhead power
lines or other electric light or power circuit, or where
it can fall into such power lines or circuits as contact
with them may be fatal.
22) STRANGULATION HAZARD. Children have
STRANGLED in cords. Keep the adapter cords and
sensor pad cord out of the reach of children.
Because of the serious strangulation risk to infants
and toddlers, parents and caregivers should NEVER
place the nursery unit within 3 feet (1 meter) of a crib.
NEVER use extension cords with AC adapters.
ONLY use the AC adapters provided.
23) Interference- This monitor uses public airwaves
to transmit signals. The Parent Unit may pick up sig-
nals or interference from other nursery monitors in
your area. Your monitor may even be picked up by
other households. To protect your privacy, make sure
both units are turned off when not in use. If you expe-
rience interference, change the channel on both
units.
24) Vibration Source- When the monitor is in use, do
NOT use a crib mobile or other crib accessories that
may produce vibrations. Other sources of vibrations
may include fans, washing machines, loud music,
etc. These sources of vibration may interfere with the
performance of your Angelcare® monitor and the
alarm will not sound if it continues to detect any
movement other than your baby's. Be sure all vibra-
tion sources are eliminated before using the monitor.
You may experience false alarms for several rea-
sons. The most common reason is the Nursery Unit
has not been turned off after you have removed your
baby from the crib. Another reason is the Sensor Pad
has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface with
the printed side facing up. The sensitivity level may
also need to be adjusted. Refer to the Movement
Sensitivity Adjustment section on P 9. Always be
sure to immediately check on baby whenever an
alarm sounds.
25) Sensor Pad- Your sensor pad can be used in any
crib that is stationary and designed to safely hold a
baby. If the crib has a spring or slat base, place a
hard board between the crib base and the Sensor
Pad measuring at least 13" x 13" (33 x 33 cm) and
1/4 inch (6 mm) thick. Only use your Angelcare®
monitor in a stationary sleeping environment such as
a crib where the Sensor Pad can rest on a complete-
ly flat, firm surface.
ALWAYS route the sensor pad cord below crib mat-
tress ONLY and out of reach of children.
IMPORTANT SAFETY INSTRUCTIONS
RELATED TO USE OF BATTERIES
1) Use ONLY the type and size of batteries specified
in the user manual. There is a risk of explosion if
batteries are replaced with an incorrect type.
2) Use ONLY AAA (LR03) rechargeable batteries
and/or the AC adapters provided for the Parent
Units. You must use only rechargeable batteries in
the Parent Unit. DO NOT use alkaline batteries or
you will severely damage the unit.
3) Charge the batteries for 15 hours prior to first use.
Be sure to have the monitor in the OFF position dur-
ing this period. ONLY use the AC adapters included
with your monitor.
4) Do NOT use these adapters with any other equip-
ments.
5) When unplugging the AC adapter from the nursery
unit, be sure it is switched to the off position. If it isn't,
the unit will revert to battery mode if batteries are
installed.
6) Do NOT use rechargeable batteries in the Nursery
Unit.
7) Do NOT dispose batteries in fire. They may
explode. Check with local regulations for possible
special disposal instructions.
6