Connecting Analyzer To Power Supply - Stihl ADG 2 Manual De Instrucciones

English
Use and store only
indoors in dry locations.
Operate at ambient temperatures
between + 5°C and + 40°C.
To reduce the risk of electric shock or
short circuit, do not insert any objects in
the analyzer's cooling slots.
Never bridge the contacts of the
analyzer with metallic objects (e.g. nails,
coins, jewellery) – short circuit. The
analyzer may be damaged by a short
circuit.
Do not operate in a hazardous location,
i.e. in a location where there are
combustible liquids (fumes), vapors or
dusts. The analyzer may produce
sparks, which may ignite the dust or
vapors – risk of explosion.
In the event of smoke or fire in the
analyzer, disconnect it from the wall
outlet immediately.
Inspect the analyzer's
power cord, the connect -
ing cord to the power tool
and the adapter for dam -
age at regular intervals. If
the power cord is dam -
aged, immediately
disconnect the plug from
the wall outlet to avoid
the risk of electric shock.
Never jerk the power cord to disconnect
it from the wall outlet. To unplug, grasp
the plug, not the cord. Have a damaged
power cord repaired by a qualified
electrician.
18
Do not use the power cord or connecting
cord for any other purpose, e.g. for
carrying or hanging up the analyzer.
Check the power cord and plug for
damage before each use. Never use
damaged cords and plugs or connecting
cords that do not comply with
regulations.
To reduce the risk of stumbling, position
and mark the power cord so that it
cannot be damaged or endanger others.
To reduce the risk of electric shock:
Always connect the cord to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power cord and plug is in good
condition.
After using the analyzer, unplug it from
the wall outlet.
Before leaving the analyzer unattended
or transporting or storing it, remove the
battery and take the adapter out of the
cordless power tool.
Store the analyzer out of the reach of
children.
Clean plastic surfaces with a cloth. Do
not use aggressive detergents. They
may damage the plastic.
Connecting Analyzer to
Power Supply
Mains voltage and operating voltage of
the analyzer must be the same.
3
Insert the mains plug (1) in the wall
N
outlet (2).
The display shows the following
information as soon as the analyzer is
connected to the wall outlet:
Analyzer
ADG 2
The analyzer then performs a self test.
During this process the light emitting
diode (3) on the analyzer glows green
for about 1 second, then yellow, then red
and goes off again.
Self test
When self test is completed:
Insert battery
Insert the battery in the analyzer –
N
see "Testing Cordless Power Tool".
2
1
ADG 2