Hardware Installation - Creative E-MU 1212M PCI Manual Del Usuario

EMU QS(En).fm Page 3 Thursday, October 26, 2006 11:09 AM

2 - Hardware Installation

Step 1: Prepare your computer
Metal
1. Turn off your computer and all peripheral devices.
brackets
2. Touch a metal plate on your computer to ground yourself and to discharge any static
electricity, and then unplug the power cord from the wall outlet.
3. Remove the computer cover.
4. Remove the metal bracket from one PCI slot. If you have the E-MU 1212
installing the Sync Daughter Card you'll need to remove the bracket from two PCI slots.
PCI slots
See the figure at left.
ISA slots
Step 2: Install the E-MU 1010 PCI card
1. Align the E-MU 1010 PCI card with the slot and press gently but firmly down into the slot
as shown in the figure opposite.
2. Do not force the E-MU 1010 card into the slot. Make sure that the gold finger connector
of the card is aligned with the PCI bus connector on the motherboard before you insert
the card into the PCI slot. If it doesn't fit properly, gently remove it and try again.
3. Secure the card to the slot using a screw (if necessary).
m
system or are
Quick Start Guide - Getting Started - 3