Silvercrest SOKL 1920 B2 Instrucciones De Montaje página 35

Do not aim the camera directly into the sun or
at other intense light sources that could affect
the image quality, and also shorten the service
life of the image sensor .
WARNING! Do not install the product
m
near flammable gases or potentially
explosives areas (e.g. paint shops)
with the wireless transmitter on, as
the radio waves emitted could cause
explosions and fire.
If you have any doubt about installation/use
of this product, consult a qualified person .
The camera must be securely fixed to the
mounting surface using the screws and wall
plugs supplied . The screws and wall plugs
supplied are suitable for "masonry" only .
Other fixings not supplied and must be
purchased .
Attention: Make sure not to drill into
m
any pipes or mains cables beneath
the mounting surface. Use a voltage/
metal detector.
The fixing points selected must be capable of
supporting the full weight of the product .
Make sure that the location planned for the
installation of the camera is well ventilated .
DANGER! Radio interference!
m
Switch the product off on aeroplanes, in
hospitals, service rooms, or near medical
electronic systems . The wireless signals
transmitted could impact the functionality of
sensitive electronics .
Keep the product at least 20 cm from
pacemakers or implantable cardioverter
defibrillators, as the electromagnetic radiation
may impair the functionality of pacemakers .
The radio waves transmitted could cause
interference in hearing aids .
Do not place the product near flammable
gases or potentially explosives areas
(e .g . paint shops) with the wireless
components on, as the radio waves emitted
can cause explosions and fire .
The range of the radio waves varies by
environmental conditions . When using the
wireless data transmission, unauthorised third
parties receiving the data cannot be excluded .
Wireless systems are exposed to interference
of telephones, microwaves, as well as other
electronic devices operating in the 2 .4 GHz
range . Maintain a minimum distance of
3 metres from such devices during installation
and operation .
Do not use the product in a complex
environment . The obstruction might affect
the electromagnetic wave and influence
the receiving range . Wall, trees and other
surroundings might absorb, reflect the
electromagnetic wave, and influence the
receiving range .
The OWIM GmbH & Co KG is not
responsible for interference with radios or
televisions due to unauthorised modification of
the product .
The OWIM GmbH & Co KG further assumes
no liability for using or replacing cables
and products not distributed by OWIM .
The user of the product is fully responsible
for correcting interference caused by such
unauthorised modification of the product, as
well as replacement of such products .
IP Code (Ingress Protection)
IP Code (Ingress Protection) indicates degrees of
protection provided by product enclosure against
access to hazardous parts, ingress of objects
and/or against ingress of water . The camera
has been classified as IP66 and is completely
protected against entry of dust and against
powerful water jets from any direction .
GB/IE 35