13
TROUBLE SHOOTING
Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with
interruptions
Low oil light glows
Low oil light glows
Overload indicator light glows
Overload indicator light glows
Overload indicator light glows
Overload indicator light glows
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-STE3000IV
Possible cause
Incorrect starting sequence
Dirty air cleaner
No fuel supply
Fault in the fuel line
Engine flooded.
Spark plug connector not placed on.
No ignition spark
Fuel cock closed
Engine oil to few
Incorrect idle adjustment
Carburetor incorrectly adjusted
Spark plug fouled
Check oil level
To less or no oil
Low voltage protection activated
High temperature protection
activated
Overload protection activated
Short circuit protection activated
NOTICE
TROUBLE SHOOTING
Solution
Observe the correct starting
sequence
Clean/replace air cleaner
Refuel
Check the fuel line for kinks
or damages
Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times
and reinstall the spark plug
Place on the spark plug
connector
Clean/replace spark plug
Check ignition cable
Open fuel cock
Check engine oil
Contact customer service
Contact customer service
Clean/replace spark plug
Check spark plug connector
Fill engine oil
Fill engine oil
Engine speed to low
Cool down the engine
To big loads
Check loads
27