Safety Shutdown - FALMEC Panoramico 90 Manual De Instrucciones

SAFETY DEVICES ON THE COOKER

Safety shutdown

If a cooking area exceeds the maximum time for oper-
ation at the same power, it is automatically switched
off and the indication of the residual heat is shown.
To reset the cooking area, touch the necessary keys.
low 1 2
Power level
Maximum
duration of
8.7 2.0 8.7
operation in
hours
The cooker switches off automatically if one or
more controls stay covered for more than 10
seconds.
To restore the proper operation:
- remove all objects from the control panel.
- clean the control panel.
- restart the cooker and the concerned area.
OVERHEATING DEVICE
Before items of the cooker can overheat, the control
reduces the used power by following this procedure
for protection measures:
- Deactivation of booster and power booster if turned
on.
- Reduction of the power level set.
- Shutdown of the cooking area concerned.
On the display of the cooking area the message "E2"
is displayed.
It is possible to restore the cooking area when the de-
fault message is off.
3 4 5 6 7 8
6.7 5.3 4.3 3.5 2.8 2.3
SAFETY INSTRUCTIONS
FOR ASSEMBLY
Install the cooker after installing kitchen cabinets and
basis.
Make sure that worktops have been veneered with
thermoresistant glue in order not to suffer deflections
or detachments.
9 P
1.9 1.5
It is forbidden to install the appliance on fridges or
freezers, washing machines, dishwashers, or tumble
driers.
ELECTRICAL SAFETY
The electrical system to which the cooker is to
be connected must be in accordance with
local standards and supplied with earthed
connection in compliance with safety regulations in
the country of use. It must also comply with European
standards regarding radio antistatic properties.
Make sure that it can't be possible to touch the power
cable of the cooker after it has been built-in and that
it is not subject to mechanical stress.
The socket used to connect the installed equipment
to the electrical power supply must be within reach:
otherwise, install a mains switch to disconnect the
machine when required.
Any changes to the electrical system must be carried
out by a qualified electrician.
Do not try to solve the problem yourself in the event
of equipment malfunction, but contact the Dealer or
an authorised Servicing Department for repairs.
18