General Guidelines; Overheating Protection; Overvoltage Protection; Safety And Information Signs - TECNA 3680 Manual De Uso

EN
Translated copy of the original Italian text
SAFETY INFORMATION
2
2.1

General guidelines

In order to maintain maximum device safety:
• operators and maintenance technicians must read
and understand the instructions for installation and
use of the device;
• all periodic maintenance operations described in
the Maintenance chapter must be carried out;
• the following safety instructions must be observed:
DANGER
„ The machine should not be used by
persons with biomedical implants. For
more information, see the "Dangers
from magnetic fields" paragraph.
„ Never touch any parts subject to
overheating. For more information,
see the "Dangers of burns and fire"
paragraph.
„ Do not use the machine near explosive
and/or flammable materials.
„ Do not use the machine if the electrical
cables are damaged.
„ Do not use the machine on wet
surfaces.
WARNING
„ Ensure that the device is connected
to a power socket equipped with an
earth connection.
„ Insert the plug fully into the socket; do
not use the socket for other devices at
the same time and do not remove the
plug by pulling the power cord.
„ Turn off the main switch and
disconnect the power cable whenever
the machine is left unattended and/or
before any maintenance operations.
CAUTION
„ Keep the power cable away from heat
sources and sharp edges.
„ Do not move the machine by pulling
on the power cable or the gun
connection cable.
WARNING
„ If any defects are noticed during use,
remove the plug and contact technical
support.
„ Periodic diagnostic checks and routine
maintenance operations should be
observed.
2.2 List of safety and protection devices
on the equipment
The machine is provided with safety devices for the
protection of workers and of the machine itself.
Tampering with, modifying or attempting to override
the machine's safety systems in any way is prohibited.

2.2.1 Overheating protection

The machine is equipped with a sensor to monitor
its temperature and alert the operator in the case of
excessive overheating.
In the event of overheating, the machine must be
left switched on to allow the coolant to circulate and
restore the temperature of the machine to normal
levels.
If the maximum limit is surpassed, an alarm message is
activated on the operator panel.
The alarm message disappears when the temperature
returns to within the required range.

2.2.2 Overvoltage protection

The machine has a fuse to protect it from power surges.
If the fuse blows, TECNA s.p.a. should be contacted for
a replacement.
2.3 Pictograms

2.3.1 Safety and information signs

The machine may have warning signs indicating risks
in the immediate vicinity, plates displaying information
and/or pictograms for its correct and safe use.
2.4 Requirement to use PPE (Personal
Protection Equipment)
WARNING
Operators must wear suitable personal
protective equipment (goggles, gloves,
aprons or other clothing) to protect
themselves from spatter of incandescent
material.
The gloves used must be resistant to high
temperatures.
EN-2