Machine Settings; Working Modes - TECNA 3680 Manual De Uso

EN
Translated copy of the original Italian text
6.4.2.2 Cap maintenance
(See attached images A7 and A18)
Press on the button to access the cap maintenance
management page.
In the cap maintenance management page (attached
image A21) you can change the number of welds that
can be made before maintenance of the electrodes is
required (for further information, see the subchapter
"Electrode maintenance check function ").
If the value is set to 0, the function is disabled.
The indicator beside the
scheduled maintenance is almost due.
6.4.2.3 Backing up programs
(See attached image A18)
Press the button to access the program backup
page.
Users with administrator rights can create a backup
copy of the welding programs on a USB flash drive.
The backup is made by plugging a flash drive into
the machine and selecting the "PROGRAM BACKUP"
option from the setup menu.
If the flash drive already contains a backup file of the
same machine, it will be overwritten.
If a flash drive containing a backup of the welding
programs is plugged into the machine, they can be
transferred to the control system.
To do this, click on the
The programs previously available on the control
system will be deleted.
A USB 2.0 port is installed on the machine solely for use
of a flash drive.
USB HARD DISKS, mouses or PCs cannot be connected
via the port.

6.4.2.4 Machine settings

(See attached image A18)
Press on the button to access the machine
program settings page.
On the settings page you can view the serial numbers
of the control unit and the inverter and also change
some machine configuration parameters (attached
image A22).
Only users with administrative rights can make
changes.
You are advised not to make any changes as these
adjustments are reserved to specialised technicians.
icon signals that
icon in the setup menu.
6.5

Working modes

Pressing the
(attached image A16).
The system can be used in three different working
modes:
• In SMART + mode
choose the welding parameters as they are
automatically determined by the control.
• In QUICK mode
selection of welding program parameters
• In FULL mode
welding program parameters.
6.5.1 SMART+ working mode
(See attached image A23)
In SMART + mode, the machine automatically identifies
the materials between the electrodes and selects the
most suitable parameters to perform the work.
During the welding process, compensation is
automatically made for any conditions that require
adjustment of the welding parameters, such as poorly
coupled metal sheets or the presence of paint or glue
between them.
The user is not required to make any adjustments,
except for setting the type of arms and electrodes used.
When the welding in the area is completed (1), the time,
current and force values that were used are displayed.
The parameters for the last welds can be viewed by
selecting their icons in area (2).
The result of the welding is shown through the icons
on the display.
The icons include:
The welding has been performed correctly.
The welding has been performed correctly,
but its execution required the use of higher
than normal parameters.
Check the cleanliness of the sheets to be
welded and the condition of the electrodes.
The welding has not been performed
correctly.
Check the cleanliness of the sheets to be
welded and the condition of the electrodes.
EN-10
icon accesses the settings menu
, the user does not have to
, the user can set a reduced
, the user can configure all the