Regulation Of The Blades; Troweling Performance; Safety Recommendations - Sima HALCON 65 Manual De Instrucciones Original

Note that the blades should rotate in the same direction as clockwise. If not so, it will
exchange between it two phase wires at the air base from one end or in the air plug the
other end of extension cable.
HALCON models, NOT TO BE USED IN THE RAIN. ALWAYS WORK WITH GOOD
LIGHT CONDITIONS.

4.3 REGULATION OF THE BLADES

HALCON Power trowel has a mechanism that regulates the inclination of the blades at all times to suit the
characteristics of the surface being treated. This mechanism is at the wheel V, Fig.5 on the end of the
handlebars and rotating it in either direction is obtained by varying inclination of the blades.

4.4 TROWELING PERFORMANCE

We recommend the use of different blades as they are to carry out preparatory (floating blades or
floating disc) or finishing the surface to be treated.
SIMA SA manufactures different types of blades, preparatory (floating) and finishing. Floating blades are
mounted paddles coupled on the finishing blades and taking into account the spin is in the sense of
clockwise. To mount preparation (floating) blades is necessary for the Trowel has placed the finishing.
Gasoline-powered models, once started the engine, the operator grasp the handle by pressing
the safety lever M, Fig.3 until it is unlocked. Then, without releasing the lever, let accelerate slowly the
motor acting on the gas lever A, Fig 3. When the acceleration reaches a certain point, the blades begin
to rotate commencing the planned work.
In general, the acceleration is adequate with the maximum engine speed, allowing the clutch to work in
optimal conditions. While moving the Trowel, the operator must act on the regulatory mechanism V,
Figure 5 to achieve the proper angle of the blades at all times.
WARNING: The stop lever is a main security component that works by stopping the engine
automatically when it is released by a neglect or loss of control of the operator. As a result, you should
be aware that once unlocked, and in normal working conditions, have to stay down on the handlebars.
When the concrete surface is too hard to be towelled, moisten it will be necessary to continue work in
good condition.
electric motor models, once the engine running, the operator grasp the handlebar lever
pressing the idler pulley until the movement is transmitted to the blades. Keeping the lever pressed was
scheduled to start on work by acting on the wheel of regulation V, Fig.5 when necessary to achieve the
proper angle of the blades.
Releasing the lever will stop the blades while the engine is running.
Note that the blades should rotate in the same direction as clockwise. If not so, it will exchange between
it two phase wires at the air base from one end or in the air plug the other end of extension cable.

4.5 SAFETY RECOMMENDATIONS

 For the first time use. The operator must extreme caution to the maximum until you gain
some skill and know clearly the reactions of the machine.
 Before starting up the machine please read the instructions and make sure safety norms
are respected. Learn how to stop the machine in a fast and safe way.
 Make sure to use this machine in perfect technical condition and fully operational.
 Do not operate the machine if you have not assembled all the protections and safeguards
that have been designed.
 It is recommended to use safety glasses, safety boots, gloves etc. Please always use
approved materials.