Checking Chain Lubrication - Stihl HTE 60 Manual De Instrucciones

English
Opening the Cap
2
1
N Swing the grip (1) to the upright
position.
N Rotate the cap about 1/4 turn
counterclockwise.
N Remove the cap.
Filling up with chain oil
N Filling up with chain oil
N Check the oil level regularly. Never
allow the oil tank to run dry.
Take care not to spill chain oil while
refilling and do not overfill the tank.
STIHL recommends you use the STIHL
filler nozzle for chain oil (special
accessory).
Closing the Cap
N
Insert the cap in the opening – with
the grip upright – the marks (2) must
line up.
N Rotate the cap clockwise as far as
stop (about 1/4 turn).
N Fold the grip down so that it is flush
with the top of the cap.
44
If the oil level in the tank does not go
down, the reason may be a fault in the oil
supply system: Check chain lubrication,
clean the oilways, contact your dealer
for assistance if necessary STIHL
recommends that you have servicing
and repair work carried out exclusively
by an authorized STIHL servicing
dealer.
Checking Chain
Lubrication
The saw chain must always throw off a
small amount of oil.
Never operate your saw without
chain lubrication. If the chain runs
dry, the whole cutting attachment
will be irretrievably damaged
within a very short time. Always
check chain lubrication and the oil
level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
HTE 60