Taking Care Of The Guide Bar; Storing The Machine - Stihl HTE 60 Manual De Instrucciones

English
Taking Care of the Guide
Bar
2
1
N Turn the bar over – every time you
sharpen the chain and every time
you replace the chain – this helps
avoid one-sided wear, especially at
the nose and underside of the bar.
N Regularly clean the oil inlet hole (1),
the oilway (2) and the bar
groove (3).
N Measure the groove depth – with
the scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Chain type Chain pitch Minimum
groove depth
Picco 3/8" P 5.0 mm
Rapid 1/4" 4.0 mm
If groove depth is less than specified:
N
Replace the guide bar.
48
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3

Storing the Machine

For periods of 3 months or longer
N Disconnect the plug from the wall
outlet.
N Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
N If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
N Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
HTE 60